Suntan’s Radial Aluminum Electrolytic Capacitor – TS13DE-CD110X

December 22, 2021 Views
Comments 0

Suntan Technology Company Limited
---All Kinds of Capacitors

Suntan’s CD110X is a radial typed aluminum electrolytic capacitor series with 85’C operating temperature, general type.

Features:
CD 110 Miniated Series Miniatured;
85’C 2000 hours Guaranteed.
Spec link: https://www.suntan.com.hk/pdf/Aluminum-Electrolytic-Capacitors/TS13DE-CD110X.pdf

If you have any interests in it, please feel free to contact our sales at sales@suntan.com.hk.
Look forward to your inquiries.

Suntan’s Radial Aluminum Electrolytic Capacitor – TS13DE-CD110X

Suntan Telles Do You Need a Replacement Capacitor With One Resistor

October 20, 2015 Views
Comments 0
Suntan Technology Company Limited
---All Kinds of Capacitors
 
My start capacitor has a resistor on it. Do I need a replacement capacitor with one?
Most replacement start capacitors will not include a resistor. You can check the condition of the old one by checking the resistance value, or just replace it with a new one. 
This should read somewhere around 10-20k Ohms and around 2 watts. The resistors are usually either soldered or crimped to the terminals. 
The purpose of the resistor is to bleed off residual voltage in the capacitor after it has been disconnected from the circuit after motor start up. 
Not all start capacitors will use one, as there are other ways to accomplish this. 
The important part is if your original capacitor had one, you'll need to replace it on the new capacitor.

For more details please check:
http://www.suntan.com.hk/Motor-Capacitors/TS13D3-CD60-Motor-Starting-Capacitor.html

More..Motor CapacitorsSu  Suntan  CD60  Motor Starting Capacitor  TS13D3-CD60  

Suntan Telles Is Your Start Capacitor Bad or Not

October 15, 2015 Views
Comments 0
Suntan Technology Company Limited
---All Kinds of Capacitors

The answer to this question is maybe. 
If your motor is slow to start, your start capacitor may have lost its capacitance rating due to wear and age, or you may have other non-capacitor related issues that have to do with other motor components.
 
For more details please check :http://www.suntan.com.hk/Motor-Capacitors/

More..Motor CapacitorsSu  Suntan  Start Capacitor  TS13D3-CD60  

Suntan Telles You What Are Typical Start Capacitor Ratings

October 13, 2015 Views
Comments 0
Suntan Technology Company Limited
---All Kinds of Capacitors
 
Most start capacitor applications use a rating of 50-1200 uf capacitance and voltages of 110/125, 165, 220/250 and 330 VAC. 
They are also usually always 50 and 60 Hz rated. Case designs are typically round and cast in black phenolic or Bakelite materials. 
Terminations are usually ¼" push on terminals with two terminals per connection post.
 
For more details please check :

Suntan Telles You What is a Start Capacitor Used For

October 8, 2015 Views
Comments 0
Suntan Technology Company Limited
---All Kinds of Capacitors
 
A start capacitor is used to briefly shift phase on a start winding in a single phase electric motor to create an increase in torque. 
Start capacitors possess a very large capacitance value for their size and voltage rating. 
As a result, they are only intended for intermittent duty. 
Because of this, start capacitors will fail after being left energized for too long due to a faulty starting circuit on a motor.
 
For more details please check :

Suntan Motor Capacitors Specification Overview Part III

October 6, 2015 Views
Comments 0
Suntan Technology Company Limited
---All Kinds of Capacitors
 
7、Start vs Run Capacitors
Start capacitors give a large capacitance value necessary for motor starting for a very short (seconds long) period of time. They are only intermittent duty and will fail catastrophically if energized too long. Run capacitors are used for continuous voltage and current control to a motor's windings and are therefore continuous duty. They are generally of a much lower capacitance value.
 
8、Are start and run capacitors interchangeable?
Yes and no. In unusual circumstances, a run capacitor could be used as a start capacitor, but the values available are much lower than the values usually available for dedicated start capacitors. The capacitance and voltage ratings would have to match the original start capacitor specification. A start capacitor can not ever be used as a run capacitor, because it could not handle current continuously (only a couple of seconds).
 
 

分页:[«]1[»]