Suntan Blog

Suntan Technology Company Limited
---All Kinds of Capacitors

Varistor is one kinds of transient voltage suppression devices which can be used instead of transient suppression diodes, zener diode and capacitor combination. Varistor IC and other devices can protect the circuit, to prevent electrostatic discharge, surges and other transient current (such as lightning, etc.) the damage caused by them. Simply use varistors and connected to the protected circuit IC or device, when the voltage value above a certain moment, the varistor resistance decreased rapidly, conducting high current, thereby protecting the IC or electrical equipment; when the voltage is lower than the varistor voltage value, the varistor resistance high, almost open, and thus will not affect the device or the normal operation of electrical equipment.

Suntan offers Plastic Film Capacitors which are the key components of power supply units. Plastic Film Capacitors help suppress interference and simultaneously decouple semiconductors or are used as DC link capacitors. Suntan Plastic Film covers a wide range of capacitance and voltage, matching a various applications such as HID lamp, photo flash, engine control unit and LCD backlight. All products are environmentaly conscious and comply with RoHs directive.

The most common type of varistor is the Metal Oxide Varistor (MOV). This contains a ceramic mass of zinc oxide grains, in a matrix of other metal oxides (such as small amounts of bismuth, cobalt, manganese) sandwiched between two metal plates (the electrodes). The boundary between each grain and its neighbour forms a diode junction, which allows current to flow in only one direction. The mass of randomly oriented grains is electrically equivalent to a network of back-to-back diode pairs, each pair in parallel with many other pairs. When a small or moderate voltage is applied across the electrodes, only a tiny current flows, caused by reverse leakage through the diode junctions. When a large voltage is applied, the diode junction breaks down due to a combination of thermionic emission and electron tunneling, and a large current flows. The result of this behaviour is a highly nonlinear current-voltage characteristic, in which the MOV has a high resistance at low voltages and a low resistance at high voltages.

Suntan is with very good support for Multilayer Metal Oxide Chip Varistor. This products is featured with Low firing, Sliver diffusion, Grain resistance, Electrical properties and it is widely used in cellular telephones and automotive electronic subassemblies. www.suntan.com.hk  is widely introduced all kinds of electrical products.

The mica group of sheet silicate (phyllosilicate) minerals includes several closely related materials having highly perfect basal cleavage. All are monoclinic with a tendency towards pseudo-hexagonal crystals and are similar in chemical composition. The highly perfect cleavage, which is the most prominent characteristic of mica, is explained by the hexagonal sheet-like arrangement of its atoms.

The word "mica" is thought to be derived from the Latin word micare, meaning "to glitter", in reference to the brilliant appearance of this mineral (especially when in small scales).

Based on Mica’s characteristic and other function .Suntan is supplying Silver mica capacitors which are high precision high stability high reliability capacitors. They are available in small values, and are mostly used at high frequencies.

Suntan is now a leading firm in the electronic component industry. Based on our unique design and processing technologies we offer a variety of ceramic products including 3mm ceramic trimmer capacitors, 5mm Trimmer Ceramic Capacitor, 6mm and 7mm Ceramic Trimmer Capacitor etc.

The following is one of our Ceramic Trimmer Capacitors,please see its features.If you are interested in other types of Ceramic Trimmer Capacitor,please visit www.suntan.com.hk for your reference.

5mm Ceramic Trimmer Capacitor Features

• As well as applications to small sized electronic apparatus, this series is designed for easy handing and is available with a variety of
• adjustment method (top, buttom, side and double sides).
• Wide mounting sizes and variable adjustment available
• Lots of capacity ranges,3pF through 90pF
• Sturdy mechanical structure against vibration or shock

A capacitor constructed by stacking, or forming into a roll, alternate layers of foil and a dielectric which consists of a plastic, such as polystyrene or Mylar, either alone or as a laminate with paper.Plastic film capacitors help suppress interference and simultaneously decouple semiconductors or are used as DC link capacitors.

Suntan have 4 types of Axial Film Capacitors, they are differ with different material and different body style.

Suntan have Metallized Polyester Film Capacitor with Cycloidal & Oval body style and Metallized Polypropylene Film Capacitor with Cycloidal & Oval body style also.

The temperature  can up to 105'C at most.

They are mainly used in different instruments, DC & AC circuit of the household equipment and the fractional frequency circuit of acoustics system.

The capacitance value of any capacitor is a measure of the amount of electric charge stored per unit of potential difference between the plates. The basic unit of capacitance is a farad; however, this unit has been too large for general use until the invention of the double-layer capacitor, so microfarad (μF, or less correctly uF), nanofarad (nF) and picofarad (pF) are more commonly used.

The capacitance of aluminum electrolytic capacitors tends to change over time, and they usually have a tolerance range of 20%. Some have asymmetric tolerances, typically −20% but with much larger positive tolerance as many circuits merely require a capacitance to be not less than a given value.Tantalum electrolytics can be produced to tighter tolerances and are more stable.

Suntan is a Hong Kong based manufacturer of Aluminum Electrolytic Capacitors, Including Snap-in type Electrolytic Capacitor, Screw type and LUG type Aluminum Electrolytic Capacitor, Axial & Radial Electrolytic Capacitor and SMD Aluminum Electrolytic Capacitor etc.

Capacitors may retain a charge long after power is removed from a circuit; this charge can cause dangerous or even potentially fatal shocks or damage connected equipment.  Service procedures for electronic devices usually include instructions to discharge large or high-voltage capacitors. Capacitors may also have built-in discharge resistors to dissipate stored energy to a safe level within a few seconds after power is removed.

Our Suntan has produce a Safety Standard Recognized Capacitor ,It’s specifications is descriped its function detailedly as follows.

Safety Standard Recognized Capacitor - Y Pictures

If you want to have a full knowledge about Safety Standard Recognized Capacitor,please visit  www.suntan.com.hk   and have a view.

Suntan Technology Company Limited
---All Kinds of Capacitors

 Ceramic capacitors are suitable for moderately high-frequency work (into the high hundreds of megahertz range, or, with great care, into the low gigahertz range), as modern ceramic caps are fairly non-inductive compared to the other major classes of capacitors (film and electrolytic). Capacitor technologies with higher self-resonant frequencies tend to be expensive and esoteric (typically, mica or glass capacitors).

Our Capacitance Change VS Temperature Characteristic; Voltage; Frequency has introduced Ceramic capacitors in detail ,If you want to find some special demand, please visit www.suntan.com.hk ,I am sure that our Ceramic capacitors and other products can make you feel satisfied.

Mica capacitors are high precision high stability high reliability capacitors. They are available in small values, and are mostly used at high frequencies.

Mica has a high dielectric strength and excellent chemical stability, making it a favoured material for manufacturing capacitors for radio frequency applications. It has also been used as an insulator in high voltage electrical equipment, and between the bars of commutators in direct current motors and generators. Mica is used because it can be split into very thin slices, and this keeps its thermal resistance low while retaining sufficient dielectric strength to prevent current from flowing across it at moderate voltages. The insulation is usually necessary when the heat sink is earthed (grounded) while the electronic component's metal surfaces will be connected to a power supply or signal line. If they were in direct contact this could form a short circuit. Heat sink insulation can also be necessary to prevent the heat sink from acting like an antenna if the component is connected to a rapidly varying signal.

Our Suntan has manage TS23, so if you are interested in this electrical capacitors, you can visit our website www.suntan.com.hk  for the detailed information, and you can send your enquiry to us for our competitive price and superior quality .I am sure if you have the first step ,we will have a good business relationship in the future. So Come on!